Rebuilt 87-91 Ford Truck Clutch Pedal Assembly F150 F250 F350 / NEW BUSHINGS

Description

Clutch & Brake Pedal Assembly removed from a 1988 F150, it should fit 87-91 2 & 4 wheel drive gas & diesel Ford F-150 / F-250 / F-350 / F450 & Large Bronco's.
This assembly was disassembled - inspected and has had its pedals cleaned and painted. It has also had new rubber foot pads installed along with 4 new main shaft bushings.
Some of these have an extra bracket on the clutch pedal ( I think they are only used with the T19 4 speed ) welded to the clutch pedal,
this one does not
. (
see picture 4
)  Everything else is the same you can always just change the clutch pedal if yours has the extra bracket. Just pop out the spring and take the nut off on the clutch pedal side. Never take the other nut off unless you are changing the clutch lever. The shaft is splined on the clutch master cylinder side and must be put back on in the exact position. If you are just doing a manual swap this extra bracket makes no difference.
The housing was also cleaned and painted with cast coat.
The part in the pictures is the exact part that you will receive, these are not stock photos. It is boxed and ready to ship.
This will be shipped within the 48 FedEx ground, so
no PO boxes
. Also if you are not in the 48, then email me and I can remove the shipping restrictions and
I can ship these using the priority mail option through the Post Office. Out of the country you can use eBays global shipping option.
I also will be listing or have listed a manual tilt steering column with new upper bearings, turn signal, and key switch soon.
#570