Ford Focus ST RS Gas Accelerator Pedal Spacer 3D Printed ABS New Design **Gray**

Description

**Expect USPS shipping, receipt, scanning and tracking information delays due to the virus.
10-15 days or more is not uncommon, if you cannot wait, please do not purchase
**
GRAY in color ***New Design, no logo, extra center support*** 3D printed ABS plastic accelerator pedal spacer for Ford Focus ST or RS 3/8” thick, much more comfortable feeling than the 1 1/2” thick ones that bring to pedal out too far. I bought my son a thick one for his ST and he took it right back off, said his legs were too long with the pedal up that far and says this one is just right. Simply remove your accelerator pedal by removing the two nuts, install the spacer over the studs and replace the pedal on top of the spacer and replace the nuts. No additional hardware is required. I did put a dab of threadlocker on the nuts before reinstallation and would recommend doing so as this will bring the nuts out closer to the end of the studs. Please ask any questions prior to bidding and I only ship within the US. I do ship same or next day, once the USPS is in possession of the item, tracking and speed of shipment is up to them. *Buyer assumes any and all responsibility and liability when purchasing and installing this item*